Barco DP2K-17BLP, User And Installation Manual

Page: 36 / 185

4. Physical installation projector
Necessary tools
• Flat torque screw driver
• Adjustable wrench
Necessary parts
• Certi fi ed power supply cord 4.0 mm², 10AWG, min. 300V, diameter between 11 mm and 21 mm
• Circuit breaker maximum 40A
How to connect
1. Remove the back cover.
2. Remove the power input cover.
3. Loosen the cable gland fi xation ring (1).
Note: The cable gland (1) is speci fi ed for cables with a diameter between 11mm and 21mm.
1
Image 4-11
Power cable connection
4. Push the stripped power supply cable through the cable gland. When using a fl exible power cord, make sure that each conductor
end is provided with an end sleeve.
Fix the cable in the cable gland by securing ring 1 with an adjustable wrench.
5. Connect the power cord with the terminal barrier strip. Use a fl at torque screw driver set to 2 Nm .
Always connect the ground wire (PE) with the connector indicated with PE on the terminal barrier strip.
Warning: Always connect fi rst the PE wire.
6. Reinstall the power connection cover and the back cover.
4.5 Connecting the DPxK-36BLP with the power net
W
ARNING
:
The total electrical installation should be protected by an appropriate rated and readily accessi-
ble disconnect switch, circuit breakers and ground fault current interrupters. The installation shall be done
according to the local electrical installation codes.
W
ARNING
:
Make sure that the voltage range of projector matches with the voltage of the local power net.
C
AUTION
:
The cross-sectional area of the conductors in the Power Supply Cord shall not be less than 4 mm 2
or AWG 10.
Necessary tools
• Flat torque screw driver 4 mm
• Adjustable wrench
32 R5906753 DPXK BLP SERIES 20/11/2017