Barco DP2K-17BLP, User And Installation Manual

Page: 26 / 185

2. General
The projector is delivered with a plastic cover inside the Lens Holder. This to prevent intrusion of dust and
foreign particles.
The lens is delivered in a separate box. For lens installation, see section “Lens & lens holder”.
2.4 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found,
fi le claim with carrier immediately. The Barco Sales and Service of fi ce should be noti fi ed as soon as possible.
The packaging of the DPxK BLP series projector is provided with a shock-watch label. If this shock-watch
label was triggered (red colored at arrival) during transport, indicates that the package was possibly roughly
handled by the transport company. In this case, the instructions mentioned on the label, should be followed,
which are: adding a note on the “bill of lading” and informing the transport company and the Barco sales and
service of
fi ce as soon as possible.
Projector Box content
After unpacking the projector it is recommended to check if all following items where included:
• One short power link cable (mono phase) (in case no UPS is used) - Installed on projector.
• A short information notice to inform the user that installation manual (this manual) is available online on the Barco website.
• Safety manual
The projector lens are not included in the package of the projector.
Mechanical check
This check should con fi rm that there are no broken knobs or connectors, that the cabinet and panel surfaces are free of dents and
scratches, and that the operating panel is not scratched or cracked. The Barco Sales and Service of fi ce should be noti fi ed as soon
as possible if this is not the case.
Tamper labels
During installation please inspect the tamper labels, if they are damaged please contact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipment was tampered with. The projectors are
tested and labeled for shipping to ensure that the system was not compromised before reaching the customers
fi nal destination.
These tamper labels can be found behind the input cover. See "Removal of the input cover", page 122.
22 R5906753 DPXK BLP SERIES 20/11/2017