Windows NT 4.0 BarcoMed C
ORONIS
software installation
49
16. When the Barco I-Switch Software InstallShield Wizard has
finished installing the software, it will tell you that it has
finished installing the software on your computer and
prompt you to click
“Finish”
to complete the setup. Click
“Finish”
to exit the Barco I-Switch Software InstallShield
Wizard and to return to the BarcoMed Product Installation
Wizard.
17. Click
“Finish”
to exit the BarcoMed Product Installation
Wizard or click
“Back”
if you wish to install additional
BarcoMed software.
18. Windows may now warn you that you must restart your
computer before the new settings will take effect.
Click
“Yes”
to restart your computer now.
Click
“No”
if you wish to restart your computer later.
Remove your BarcoMed Software CD from its drive and click
“Yes”
to restart your computer.
Special Note:
Even if Windows does not warn you that you
must restart your computer before the new settings will take
effect, you must restart your computer before the new
settings will take effect.
19. When your computer restarts, select
“NT Version 4.0 (VGA
Mode)”
. Log in using an account with administrator
privileges and set the resolution of your C
ORONIS
Display
Panel(s).
Setting the Resolution of Your
C
ORONIS
Display Panel
1. After you have logged in using an account with
administrator privileges per “step 19” above, Windows NT
will launch the “Invalid Display Settings” dialog box, Click
“OK”
.
2. Windows will launch the “Display Properties Control Panel”.
Click on the
“Settings”
tab and click on the
“List all Modes”
button (figure 20 on page 50).
Summary of Contents for CORONIS 1MP
