![background image](http://html1.mh-extra.com/html/barco/coronis-1mp/coronis-1mp_installation-and-user-manual_3869470157.webp)
Single Source Master
158
Setting the resolution of your C
ORONIS
1MP display
In order to set the resolution of your C
ORONIS
1MP display you
must be logged in using an account with administrator privileges.
1. To set the resolution of your Coronis 1MP display(s) right click
on the
desktop
and select
“Properties”
.
2. Select the
“Settings”
tab.
3. Select the
rectangle
that represents the first C
ORONIS
1MP
display attached to the BarcoMed C
ORONIS
display controller
you are working with.
NOTE:
If you are using the VGA capabilities of your
BarcoMed C
ORONIS
display controller, the resolution for the
first display may be set to a VGA resolution of “640 x 480”
pixels with 16 colors and a default refresh rate. If your
BarcoMed C
ORONIS
controller is not running VGA, the display
may not be enabled yet. To enable the display, check the
“Extend my Windows desktop onto this monitor”
checkbox
,
but do
NOT
click the
“Apply”
button at this time.
If you installed your BarcoMed C
ORONIS
drivers in
SingleView
mode (default for Windows 2000) there will be one
rectangle for the virtual display representing the two heads
controlled by each BarcoMed C
ORONIS
display controller.
If you installed your BarcoMed C
ORONIS
drivers in
DualView
mode (default for Windows XP) there will be a rectangle
representing each head controlled by each BarcoMed C
ORONIS
display controller. This will be true even if you have only one
display connected to your BarcoMed C
ORONIS
controller. Both
displays of a display controller cannot be enabled at the
same time unless their display properties match. If necessary
detach the second display of the BarcoMed C
ORONIS
display
controller you are working with by right clicking on the
rectangle
that represents it, deselect
“Attached”
and click
the
“Apply”
button.
Tip:
Since Windows 2000 and Windows XP will not let you
detach the primary display connected to a particular
Summary of Contents for CORONIS 1MP
