Barco BarcoReality SIM 6 Ultra II, Owner'S Manual

Page: 23 / 223

3. Connections
Lamp run time is
x
hours.
Operating the lamp
longer than
x
hours
may damage
the projector.
<ENTER> to reset the
lamp runtime.
Please replace
the lamp.
Menu 3-1
The total lifetime of the lamp for a safe operation is “x” hours max, do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.
Press
ENTER
to reset the lamp runtime.
C
AUTION
:
Using a lamp for more than its recommended life time is dangerous as the lamp could explode.
3.3 Switching to standby
How to switch to standby?
1. Press
STANDBY
for 2 seconds until the messages
Saving data please wait
is displayed.
Saving data, please wait
Image 3-3
W
ARNING
:
When switching to standby the projector waits for 30 sec. before it can be restarted. During this
period the LED display will show a jumping square with a dash. After one minute, two dashes will be displayed
and the projector can restart.
3.4 Switching off
How to switch off the projector?
To switch off the projector, handle as follow :
1. Press
STANDBY
key for 2 seconds. When the message
Saving data, please wait
is displayed, do not press any longer on the
STANDBY
key otherwise the projector will restart.
When switching to standby the projector waits for 1 minute before it can restart again. During this period the LED display will
show a jumping square with a dash. After one minute, two dashes will be displayed and the projector can restart.
Warning: Let cool down the projector at least 10 min.
2. Switch off the projector with the power switch.
3.5 Source Specifications
BarcoReality SIM6 Ultra II Source Specifications
Critical source specifications:
•
Maximum Horizontal frequency of 115 kHz.
• Maximum pixel frequency of 205 MHz.
R5976707 REALITY SIM 6 ULTRA II 01/02/2005 19