Bandit BTC-150, Operating Instructions Manual

Page: 100 / 113

Bandit
98
Copyright 3/19
MODEL BTC-150
245811760545 29Dec2017 Page 19
Maintenance
Maint2 shows the communication status between each device that is communicating over the
CAN networks (there are 3 CAN networks on this machine, CAN1 is a CANopen network for the
Output Modules and C1. CAN2 is a J1939 network for everything else except Tether. CAN3 is a
J1939 network for the Tether only).
The red number behind many of the device descriptions is an error count. Each time
communication is lost with that device it is counted up to a maximum of 15 until keyswitch is
cycled and that memory is cleared. This is to provide a limited history of errors in case an
operator is unable to watch this page continuously and likely miss a Green LED momentarily
showing Red. If the machine exhibits erratic behavior or abruptly jumps in and out of
controllability, check that communication between all devices is Green=good.
The red percentage behind C1 to Display is CAN2 J1939 busload, which measures how many
total messages are being sent on that CAN network.
1. Navigate back to Engine page.
2. and 6. Navigate to and from a total of 5 Maintenance pages.
7. The Average GPH is calculated in Controller1 and can be reset by pressing this button on
Maint2. Avg GPH will only accumulate when Engine speed is above 500rpm.
(Communication directly with Display will start out Green even if the device is not connected
and can possibly show a false positive. The Display needs to see good comm with a device first,
then if comm is lost the status will turn red. This is not true for comm directly with Controller1,
C1 can tell if a device is missing right away).
2
1
7
3
4
8