Bandit
48
Copyright 3/19
MODEL BTC-150
CAB TILTING INSTRUCTIONS
MAINTENANCE
1. Read all instructions before starting.
2. Make sure the cutter head is resting on the ground.
3. Follow all pre-maintenance shut down procedures.
4. Remove the cab lock bolts. See Figure 2.
5.
Switch the Main Battery Disconnect Switch to the "Off" position. See Figure 1.
6. Switch the Cab Tilt Battery Disconnect Switch to the “On” position. See Figure 1.
7. Push the Cab Lift Lever up to lift the cab. See Figure 3.
8. Pin the cylinder locks in place before doing anything under the cab. See Figure 4.
9. To lower the cab reverse the steps.
DANGER
!
DANGER
!
Before attempting any type of maintenance, disengage clutch or cutter head engagement, wait for the cutter
head to come to a complete stop, place the cutter head on the ground, turn off engine, remove the ignition
key, make sure the ignition key is in your possession, and wait 2 minutes then disconnect the battery. Make
sure the cutter head is set on the ground or securely blocked up and also chained before doing any work around
or under it.
DO NOT go near the rotating cutter head for any reason. DO NOT go near the cutter head while the engine
is running or the cutter head is coasting to a stop. Contact with a rotating cutter head will result in serious
bodily injury or death.
Before attempting any type of maintenance or service work under the cab make sure the cylinder lock is
in place.
DANGER
!
Summary of Contents for BTC-150
