Section 1
General Information
Installation 3-13
MN1230
Figure 3-7 Keypad Mode Connection Diagram
EXTERNAL TRIP
J1A
ANALOG OUT 1
ANALOG OUT 2
OUT 1–
OUT 1+
OUT 2–
1
2
3
4
5
6
7
ANALOG GND
J1B
OUT 2+
OUT 3–
OUT 3+
OUT 4–
OUT 4+
OUT 1
OUT 2
OUT 3
OUT 4
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
No
Connection
No
Connection
Note 1
Note 2
Notes:
1.
Refer to Analog Outputs description in this section.
2.
Refer to Opto Isolated Outputs description in this
section.
ENABLE
Refer to Figure 3-17
N.C.
V
ext
Customer
Supplied
+24VDC Source
N.C.
GND
ext
CREF
J1B-8
CLOSED allows current to flow in the motor.
OPEN disables the control and motor coasts to a stop (if Level 2 Protection block,
LOCAL ENABLE INP is set to ON). This input is optional.
J1B-16
OPEN causes an external trip to be received by control. The control will disable and
display External Trip when programmed “ON”. If J1B-16 is connected, you must set
Level 2 Protection block, External Trip to “ON” to recognize the J1B-16 input.
Summary of Contents for 29M
