4-6 Programming & Operation
MN1230
Program Mode Continued
Changing Parameter Values when Security Code Not Used
Use the following procedure to program or change a parameter already programmed into
the control when a security code is not being used.
The example shown changes the operating mode from Keypad to Bipolar.
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
Display mode. Stop LED on.
Press PROG key
Access programming mode.
Press
Y
or
B
key
Scroll to Level 1 Input Block.
Then press ENTER to access
Input Block.
Press ENTER to access INPUT
block parameter.
Press PROG key
Access Operating Mode.
Keypad mode shown is the
factory setting.
Press
Y
key
Scroll to make your selection.
Typical selection.
Press ENTER or PROG
Save selection to memory.
Press RESET to cancel selection
without saving to memory.
Press
Y
key
Scroll to menu exit.
Press ENTER key
Return to Input Block.
Press DISP key
Return to Display Mode.
Typical display mode.
Summary of Contents for 29M
