Section 1
General Information
3-16 Installation
MN1230
15 Speed 2-Wire Mode
In this mode, 15 preset motor speeds are stored during setup and selected during
operation. Switch Truth Table is defined in Table 3-5.
Operation in the 15 Speed 2-Wire mode is controlled by the Opto Isolated inputs at
J1B-11 through J1B-15. The Opto inputs can be switches as shown in Figure 3-9 or logic
signals from another device. The External Trip Opto Input at J1B-16 is active if
connected as shown and the Level 2 PROTECTION block, EXTERNAL TRIP parameter
is set to ON.
Switched inputs at J1B-11 through J1B-14 allow selection of 15 preset speeds and
provide Fault Reset as defined in Table 3-5.
Table 3-5 Switch Truth Table for 15 Speed, 2 Wire Control Mode
Function
J1B-11
J1B-12
J1B-13
J1B-14
Preset 1
Open
Open
Open
Open
Preset 2
Closed
Open
Open
Open
Preset 3
Open
Closed
Open
Open
Preset 4
Closed
Closed
Open
Open
Preset 5
Open
Open
Closed
Open
Preset 6
Closed
Open
Closed
Open
Preset 7
Open
Closed
Closed
Open
Preset 8
Closed
Closed
Closed
Open
Preset 9
Open
Open
Open
Closed
Preset 10
Closed
Open
Open
Closed
Preset 11
Open
Closed
Open
Closed
Preset 12
Closed
Closed
Open
Closed
Preset 13
Open
Open
Closed
Closed
Preset 14
Closed
Open
Closed
Closed
Preset 15
Open
Closed
Closed
Closed
Fault Reset
Closed
Closed
Closed
Closed
Summary of Contents for 29M
