Section 1
General Information
Troubleshooting 5-3
MN1230
Table 5-4 Fault Messages
FAULT MESSAGE
DESCRIPTION
Current Sens FLT
Defective phase current sensor or open circuit detected between control board and current
sensor.
DC Bus High
Bus over voltage condition occurred.
DC Bus Low
Bus under voltage condition occurred.
Feedback Loss
Check resolver connections; noise on resolver lines or resolver power supply loss.
External Trip
An external over temperature condition occurred or open circuit on J1-16.
Following ERR
Excessive following error detected between command and feedback signals.
GND FLT
Low impedance path detected between an output phase and ground.
INT Over-Temp
Temperature of control heatsink exceeded safe level.
Invalid Base ID
Control does not recognize power base ID.
Logic Supply FLT
Logic power supply not working properly.
Lost User Data
Battery backed RAM parameters have been lost or corrupted.
When fault cleared (Reset), the control will reset to factory preset values.
Low INIT Bus V
Insufficient bus voltage on startup.
Memory Error
EPROM error occurred. Contact Baldor.
New Base ID
Control board was changed since last operation.
No Faults
Fault log is empty.
No EXB Installed
Programmed operating mode requires an expansion board.
Over Current FLT
Instantaneous over current condition detected by bus current sensor.
Overload
Output current exceeded 2.5 second rating.
Over speed
Motor RPM exceeded 110% of programmed MAX Motor Speed.
m
P Reset
Power cycled before the residual Bus voltage reached 0VDC.
Power Supply
Affects shared bus multi axis systems only. Indicates power supply fault condition.
PWR Base FLT
Desaturation of power device occurred or bus current threshold exceeded.
Torque Prove FLT
Unbalanced current between all 3 motor phases.
User Fault Text
Custom software operating fault occurred.
Co-Processor FLT
Fault detected in the Co-Processor function.
Feedback
Indicates a problem with the feedback device (resolver).
User Fault Text
Custom software operating fault occurred.
Summary of Contents for 29M
