Baldor 22H series, Installation & Operating Manual

Page: 135 / 140

Section 1
General Information
A-6 Appendix A MN722
Table A-3 Power Output Parameter Block Values Level 2
Continued
Level 2 Blocks - Continued
Block Title Parameter P# Adjustable Range Factory User
Setting
BRAKE RESISTOR OHMS 2601 0-255 Ohms Factory Set
ADJUST
RESISTOR WATTS 2602 0-32767 Watts Factory Set
DC BRAKE CURRENT 2603 0-100% 0%
PROCESS
CONTROL
PROCESS
CONTROL
PROCESS
CONTROL
PROCESS FEEDBACK 2701 POTENTIOMETER
+/-10VOLTS
+/-5 VOLTS
4-20mA
5V EXB
10V EXB
4-20mA EXB
3-15 PSI EXB
TACHOMETER EXB
NONE NONE
PROCESS INVERSE 2702 ON, OFF OFF
SETPOINT SOURCE 2703 SETPOINT CMD
POTENTIOMETER
+/-10VOLTS
+/-5 VOLTS
4-20mA
5V EXB
10V EXB
4-20mA EXB
3-15 PSI EXB
TACHOMETER EXB
NONE SETPOINT
CMD
SETPOINT COMMAND 2704 –100% to +100% 0.0 %
SET PT ADJ LIMIT 2705 0-100% 10.0 %
PROCESS ERR TOL 2706 1-100% 10 %
PROCESS PROP GAIN 2707 0-2000 0
PROCESS INT GAIN 2708 0-9.99 HZ 0.00 HZ
PROCESS DIFF GAIN 2709 0-1000 0
FOLLOW I:O RATIO 2710 (1-65535) : (1-20) 1:1
FOLLOW I:O OUT 2711 1-65535 : 1-65535 1:1
MASTER ENCODER 2712 50-65535 1024 PPR
COMMUNICATIONS PROTOCOL 2801 RS–232 ASCII, RS-485 ASCII RS–232
ASCII
BAUD RATE 2802 9600, 19.2KB, 38.4KB, 57.6KB,
115.2KB, 230.4KB 9600
DRIVE ADDRESS 2803 0 - 31 0