Section 1
General Information
Receiving & Installation 3-25
MN722
Power Output Control Board Connections
Eight operating modes are available in the Series 22H vector control. These operating
modes define the basic motor control setup and the operation of the input and output
terminals. After the circuit connections are completed, the operating mode is selected by
programming the Level 1 Input block, Operating Mode parameter.
Available operating modes include:
•
Keypad Control
•
Standard Run, 3 Wire Control
•
15 Speed, 2 Wire Control
•
Fan Pump, 2 Wire Control
•
Fan Pump, 3 Wire Control
•
Bipolar Speed or Torque
•
Process Control
•
Serial
Note: The Serial operating mode requires one of the optional Serial Interface
expansion boards (RS232 or 422/485). Installation and operation information
for these serial expansion boards is provided in Serial Communications
expansion board manual MN1310. This manual is shipped with the serial
expansion board.
Summary of Contents for 22H series
