Section 1
General Information
3-26 Receiving & Installation
MN722
Keypad Mode Connections
To operate in the keypad mode, set the Level 1 Input block, Operating Mode parameter to
Keypad. In this mode, the External Trip input is active (if the Level 2 Protection block,
External Trip parameter is set to ON), the Enable input is active (if the Level 2 Protection
block, Local Enable INP is set to ON) and the Opto Outputs are active. Both analog
outputs remain active. Connections are made as shown in Figure 3-11.
The STOP key can operate in either of two ways:
S
Press STOP key one time to brake or coast to stop (as set in the Level 1
Keypad Setup block, Keypad Stop Mode parameter).
S
Press STOP key two times to disable control.
Summary of Contents for 22H series
