Section 1
General Information
4-8 Programming & Operation
MN722
Program Mode Continued
Changing Parameter Values when Security Code Not Used
Use the following procedure to program or change a parameter already programmed into
the control when a security code is not being used.
The example shown changes the operating mode from Keypad to Bipolar.
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
Display mode. Stop LED on.
Press PROG key
Access programming mode.
Press
Y
or
B
key
Scroll to Level 1 Input Block.
Press ENTER to access INPUT
block parameter.
Press ENTER key
Access Input Block.
Keypad mode shown is the
factory setting.
Press ENTER key
Access Operating Mode
parameter.
Keypad mode shown is the
factory setting.
Press
Y
key
Scroll to change selection.
At flashing cursor, select desired
mode, BIPOLAR in this case.
Press ENTER
Save selection to memory.
Press ENTER to save selection.
Press
Y
key
Scroll to menu exit.
Press ENTER key
Return to Input Block.
Press DISP key
Return to Display Mode.
Typical display mode.
Summary of Contents for 22H series
