AUKS AL-H18/4DR1(U), Service Manual

Page: 151 / 161

AUKS DC Inverter 1 Drive1 50HZ R410A Controller
151
4. Parameters setting of Indoor Unit
Indoor models and parameters can be set by remote control, wired remote control.
1)
Setting of Indoor Model Based on Remote Controller
(1).With the controller off, pressing the two white button simultaneously more than 5 seconds or more to
enter parameters settting. This status displays only temperature and time parameters, temperature display
area shows “Serial number" parameters, the range is 0-99. Time display area shows "Set value", the
range is 0-255. The initial value is 1.
Initial value
Serial No. 77 Set value 222
(2). By pressing“ / ” to set serial and -, Parameters within the serial number displays from
0 to 99 in circulation. Set serial number to 77, as display in the photo above.
By pressing“CLEAN”and “ECO” button to set value and -. Parameters within the value number
displays from 0 to 255 in circulation. Set value number to 222, as display in the photo above.
After setting the two numbers, press the MODE button to confirm sending to ODU.
After confirm the setting parameter, then operate these buttons, you can continue to select the parameter
number and setting.
(3).In the parameter setting state, pressing the two white button simultaneously more than 5 seconds or more
to enter parameters settting, and return to normal use status.
Setting Value
Serial No.