AUKS AL-H18/4DR1(U), Service Manual

Page: 142 / 161

AUKS DC Inverter 1 Drive1 50HZ R410A Controller
142
15. “ECO”button
* In cooling mode, press this button, the unit will run “ ECO ” economic operation mode which takes the
least power consumption.
* After running for 8h, it will automatically quit. You can press “ ECO ”button once again to quit.
* Note: The unit will turn off automatically if the timing mode is running out of time.
16.Two white button: Addressing set
* With the controller off, pressing the two white button simultaneously more than 10 seconds
or more to enter address setting. This status displays only temperature and time
parameters, temperature display area shows “Serial number" parameters, the range is 0-99.
Time display area shows "Set value", the range is 0-255. The initial value is 1.
* By pressing “ /
”to set serial and -. Parameter within the serial number displays from
0 to 99 in circulation.
* By pressing “
ECO ” and “ iCLEAN ” to set value and -.Parameters within the
value number displays from 0 to 255 in circulation. After setting the two numbers, press
the MODE button to confirm sending to ODU.
Remote conntroller: K series
POWER button : Switch the unit ON/OFF.
MODE button : Select mode , push the button one time, then the operation modes will change in turn as
Auto-Cooling-Dehumidify-Heating
TEMP + button and TEMP - button : Temperature adjustment range: 16~32
FAN button : Change the fan speed will change in turn as: Low-Medium-High-Auto
SWING button 1 : Press this button for the first time when operation, it will start the up and down swing
function. Push the button for the second time, cancel the swing function.
SWING button 2 : Press this button for the first time when operation, it will start the right and left swing