8
User Manual smar-tel-i
Get
ti
ng St
art
e
d
Following a few instructions is all that is necessary in order to start operations with your
smar-tel-i. In order that smar-tel-i can function as a system telephone with the internal S
0
bus of your AUERSWALD PBX, the following requirements must be met:
앫
One of the internal Multiple Subscriber Numbers (MSNs) 41-48 has been entered as
MSN1 in smar-tel-i (refer to the chapter Installing MSNs on page 9).
앫
Your PBX uses the 1.1k software version or higher (confirm using the operator pro-
gram). Should this not be the case, please execute a PBX software update (refer to the
PBX manual).
h
Included in your smar-tel-i data medium package is an operator software which you can
easily use to program your smar-tel-i. Programming the smar-tel-i is accomplished
through the connected PBX (similar to programming the PBX itself through its serial
port or, beginning with software-version 2.0 with an ISDN PC card via the internal S
0
bus).
Please observe the safety precautions on page 76.
Follow and execute the instructions below in order (when being connected, each plug must
audibly seat so that it can be heard):
쐃
Connect the coiled receiver cord to the receiver by pushing the cord plug into the socket
on the bottom end of the receiver.
쐇
The other plug of the coiled cord which is still free is inserted into the socket on the left
side of the smar-tel-i (refer to Illustration 1 on page 6 / item
씊
).
쐋
One plug of the smooth connecting cable is inserted into the socket located on the back
side of the smar-tel-i (refer to Illustration 1 on page 6 / item
씋
).
쐏
The other end of the smooth connecting cable is connected to an IAE socket of the inter-
nal S
0
bus of your AUERSWALD PBX.
At this point, the smar-tel-i executes a self-test. The LEDs light up and the messages
“Please wait“ and “Auerswald smar-tel-i“ are displayed. Data exchange between smar-tel-i
and the PBX immediately follows.
When initially connecting smar-tel-i to the AUERSWALD PBX, it does not have a valid sub-
scriber number (41-48) as a MSN. In this instance, the display notifies you within a few sec-
onds about the necessary entry. The following chapter explains how you proceed with this
entry.
Then the data exchange between the two devices continues. smar-tel-i is ready for opera-
tion when the LCDs extinguish and the display appears as follows (e. g. when connected to
an ETS-4308 I):
(only for initial connection or after a power failure)
After a few seconds, this display changes and goes into the normal non-working status of
the smar-tel-i (the time is taken from the PBX):
3
Getting Started
3. 1
Connecting the telephone
smar-tel-i ETS-4308I
--> List
13.12.97 14:15
--> List
