24
User Manual smar-tel-i
Oper
ati
o
n
If you are in the middle of a consultation call, the connection with that party must not neces-
sarily be terminated. It is possible to speak alternately with both parties (alternating). To
change between the two, press the respective soft-key under “Con1“ or “Con2“.
h
Tip: Refer to page 23.
During a conference, you can speak with two parties at the same time.
Example: From a consultation call initiate a conference, and after a while switch both
parties together.
h
When one of the parties hangs up the receiver, continue calling with the other party
in a normal fashion.
The parties whom you have called are switched together when you replace the
receiver. If you want to switch two subscribers, you must either configure a correspond-
ing user authorization for your telephone, or initiate one of the two external access lines
with “67“ and the external line code “0.“
4. 4. 4
Alternating Between Two Calls
4. 4. 5
Initiating a Conference with Two Callers
Conf
A
You are in the middle of a consultation call.
Switch all three parties together.
Con1
A
The telephone number of the subscriber with
whom you last spoke is displayed (in this case
,the second party called).
Switch to the telephone number of the external
subscriber in order to check call charges, for
example.
a
Switch the two parties together.
If you do not operate your smar-tel-i with an AUERSWALD PBX, but rather connect it
directly to the network termination of your EURO-ISDN interface, then simply repla-
cing your receiver will deactivate the connection between all three parties.
Pressing the soft-key under “End“ will deactivate the connection to the subscriber
whose telephone number appears in the display.
If the soft-key “Split“ is pressed instead of “End,“ then the connection to the subscri-
ber shown in the display will not be deactivated. You continue to speak with him while
the other party now waits on hold. It is now possible to alternate between the two par-
ties.
2: kitchen
End Con1 Conf Cost
C2: kitchen
End Con1 split Cost
C1: Müller
End Con2 split Cost
