28
User Manual smar-tel-i
Oper
ati
o
n
When one or more user‘s accounts are installed in your smar-tel-i, a call can only be initiated
after entering a valid account number. (Refer to the chapter User Accounts on page 46).
Example: You have a user‘s account. Initiate a call.
h
In order to initiate a call, the account credit must equal at least two charge units.
Should sufficient credit be indicated but, when dialing, the display “Cost Account
Empty“ appears, then a cost account has been installed in the AUERSWALD PBX
in addition to the user account in the telephone. (Refer to the PBX User Manual).
If you install users accounts in the telephone and wish to limit a user to internal calls,
this can be achieved by installing user account with a credit of two charge units. As long
as only internal calls are made over this account, the credit will remain unused.
If you have enabled the transmission of your telephone number with outgoing calls (refer to
the chapter Call Number Display on page 58), but would like to restrict this function for indi-
vidual calls, then such calls should be initiated as follows.
Example: Restrict the transmission that diplays your telephone number.
h
The ISDN feature CLIR (calling line identification restriction at the B-subscriber) must
be requested from and activated by your provider.
Conversely, a continually restricted call number display can be reactivated before
each outgoing call. (Refer to the chapter Call Number Display on page 58).
4. 6
Dialing with an Installed Users Account
Acct
A
Prepare to enter your account number.
ok
rA
Enter and confirm your 4-digit account num-
ber. (The digits are displayed as stars (****)).
The credit on your account is displayed.
Initiate the call as usual.
4. 7
Non-display of MSN for Ensuing Calls
-->
A
Prevent the display of your telephone number
with the next outgoing call.
Initiate the call as usual.
13.12.97 15:32
Acct
Acct-No.: _
ok del
120.00 DM 15:32
--> List
13.12.97 14:15
--> List
13.12.97 14:15
xxx List
