AudioCodes Media Pack MP-124, User Manual

Page: 440 / 584

User's Manual 440 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
down (i.e., physically disconnected).

[2] = Lifeline is activated upon a power outage, when the link is
down (physically disconnected), network failure (logical link
disconnection), or when the Trunk Group is in Busy Out state
(see the EnableBusyOut parameter).
The Lifeline (FXS) phone is connected to the following port:

MP-11x FXS-only device: FXS Port 1

MP-118 FXS/FXO device: FXS Ports 1 to 4
For the FXS-only device, FXS Port 1 connects to the POTS
(Lifeline) phone as well as to the PSTN / PBX, using a splitter
cable. For the combined FXS / FXO device, the FXS ports are
provided with a lifeline by their corresponding FXO ports which are
connected to the PSTN / PBX (i.e., FXO Port 5 provides a lifeline
for FXS Port 1, FXO Port 6 provides a lifeline for FXS Port 2, and
so on).
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only to FXS interfaces.

To enable Lifeline upon a network failure, the LAN watch dog
must be activated (i.e., set the parameter EnableLANWatchDog
to 1).

For information on Lifeline cabling, refer to the Installation
Manual.
Web: Delay After Reset [sec]
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)

[1] Enable
43.3.2 SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
Table 43-16: SIP Test Call Parameters
Parameter Description
Web: Test Call DTMF
String
[TestCallDtmfString]
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". An
empty string means that no DTMF is played.
Web: Test Call ID
[TestCallID]
Defines the test call prefix number ( ID ) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is