AudioCodes Media Pack MP-124, User Manual

Page: 206 / 584

User's Manual 206 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
descending cyclic order is selected. The next lower channel
number in the Hunt Group is always selected. When the
device reaches the lowest channel number in the Hunt
Group, it selects the highest channel number in the Hunt
Group, and then starts descending again.

[4] Descending = The highest available channel in the Hunt
Group is selected, and if unavailable, the next lower channel
is selected.

[5] Dest Cyclic Ascending = The channel is
selected according to the called number. If the called number
isn't found, the next available channel in ascending cyclic
order is selected.
Note: If the called number is located, but the port associated
with the number is busy, the call is released.

[6] By Source Phone Number = The channel is selected
according to the calling number.

[9] Ring to Hunt Group = The device allocates IP-to-Tel calls
to all the FXS ports (channels) in the Hunt Group. When a
call is received for the Hunt Group, all telephones connected
to the FXS ports belonging to the Hunt Group start ringing.
The call is eventually received by whichever telephone first
answers the call (after which the other phones stop ringing).
This option is applicable only to FXS interfaces.

[11] Dest Ascending = The device allocates a
channels to incoming IP-to-Tel calls as follows:
a. The device attempts to route the call to the channel that
is associated with the destination (called) number. If
located, the call is sent to that channel.
b. If the number is not located or the channel is unavailable
(e.g., busy), the device searches in ascending order for
the next available channel in the Trunk Group. If located,
the call is sent to that channel.
c. If all the channels are unavailable, the call is released.
Note: If this parameter is not configured for the Hunt Group,
then its channel select method is according to the global
parameter, ChannelSelectMode.
Registration Mode
[TrunkGroupSettings_Registrati
onMode]
Defines the registration method for the Hunt Group:

[1] Per Gateway = (Default) Single registration for the entire
device. This is applicable only if a default Proxy or Registrar
IP is configured and Registration is enabled (i.e., parameter
IsRegisterUsed is set to 1). In this mode, the SIP URI user
part in the From, To, and Contact headers is set to the value
of the global registration parameter, GWRegistrationName or
username if GWRegistrationName is not configured.

[0] Per Endpoint = Each channel in the Hunt Group registers
individually. The registrations are sent to the 'Serving IP
Group ID' if defined in the table, otherwise, it is sent to the
default Proxy, and if no default Proxy, then to the Registrar
IP.

[4] Don't Register = No registrations are sent by endpoints
pertaining to the Hunt Group. For example, if the device is
configured globally to register all its endpoints (using the
parameter ChannelSelectMode), you can exclude some
endpoints from being registered by assigning them to a Hunt