AudioCodes Media Pack MP-124, User Manual

Page: 264 / 584

User's Manual 264 Document #: LTRT-65422
MP-11x & MP-124

To configure the Charge Codes:
1. Open the Charge Codes Table page ( Configuration tab > VoIP menu > GW and IP
to IP submenu > Analog Gateway submenu > Charge Codes ). Alternatively, you can
access this page from the Metering Tones page (see 'Configuring Metering Tones' on
page
262 ).
Figure 25-3: Charge Codes Table Page
2. Configured the charge codes, as required. For a description of the parameters, see
the table below.
3. Click Submit to apply your changes.
4. To save the changes to the flash memory, see 'Saving Configuration' on page 324 .
Table 25-1: Charge Codes Table Parameter Description
Parameter Description
End Time
[ChargeCode_EndTime<1-4>]
Defines the end of the time period in a 24 hour format, hh . For
example, "04" denotes 4 A.M.
Notes:

The first time period always starts at midnight (00).

It is mandatory that the last time period of each rule end at
midnight (00). This prevents undefined time frames in a
day.
Pulse Interval
[ChargeCode_PulseInterval<1-4>]
Defines the time interval between pulses (in tenths of a
second).
Pulses On Answer
[ChargeCode_PulsesOnAnswer<1-
4>]
Defines the number of pulses sent on answer.
25.4 Configuring FXO Settings
The FXO Settings page allows you to configure the device's specific FXO parameters. For
a description of these parameters, see 'Configuration Parameters Reference' on page
421 .
Note: The FXO Settings page is available only for FXO interfaces.