Version 6.6
543
MP-11x & MP-124
User's Manual
43. Configuration Parameters Reference
Parameter
Description
Notes:
This parameter is applicable only if silence is detected
according to packet count
(FarEndDisconnectSilenceMethod is set to 1).
For this parameter to take effect, a device reset is
required.
[BrokenConnectionDuringSilence]
Enables the generation of the BrokenConnection event
during a silence period if the channel’s NoOp feature is
enabled (using the parameter NoOpEnable) and if the
channel stops receiving NoOp RTP packets.
[0]
Disable (default)
[1]
Enable
Web: Disconnect Call on Busy Tone
Detection
EMS: Disconnect On Detection End
Tones
[DisconnectOnBusyTone]
Determines whether a call is disconnected upon detection
of a busy tone.
[0]
Disable = Call is not disconnected upon detection of
a busy tone.
[1]
Enable = (Default) Call is released upon detection of
busy or reorder (fast busy) tone.
Notes:
This parameter is applicable only to FXO interfaces.
This parameter can also be configured in a Tel Profile.
Polarity (Current) Reversal for Call Release (Analog Interfaces) Parameters
[SetDefaultLinePolarityState]
Defines the FXO line polarity, required for DID signaling.
[0]
= Positive line polarity
[1]
= Negative line polarity
[2]
= (Default) Auto - The device detects the polarity
upon power-up or upon insertion of the RJ-11 cable,
and uses it as a reference polarity.
Typically, if the RJ-11 cabling is connected correctly
(without crossing, Tip to Tip, Ring to Ring), the Tip line is
positive compared to the Ring line. In this case, set this
parameter to 0. With this configuration, the device
assumes that the idle line polarity is Tip line positive.
When the device receives a SIP INVITE, it checks the FXO
line polarity. If the polarity is "Reversed", it skips this FXO
line and goes to the next line.
Notes:
To take advantage of this new feature, configure all
FXO lines as a single Trunk Group with ascending or
descending channel select mode, and configure routing
rules to route incoming INVITE messages to this Trunk
Group.
This parameter is applicable only to FXO interfaces.
Web: Enable Polarity Reversal
EMS: Enable Reversal Polarity
[EnableReversalPolarity]
Enables the polarity reversal feature for call release.
[0]
Disable = (Default) Disable the polarity reversal
service.
[1]
Enable = Enable the polarity reversal service.
If the polarity reversal service is enabled, the FXS interface
changes the line polarity on call answer and then changes
Summary of Contents for Media Pack MP-124
