AudioCodes Media Pack MP-124, User Manual

Page: 148 / 584

User's Manual 148 Document #: LTRT-65422
MP-11x & MP-124

To configure T.38 mode using SIP Re-INVITE messages:
1. In the SIP General Parameters page ( Configuration tab > VoIP menu > SIP
Definitions > General Parameters ), set the 'Fax Signaling Method' parameter to T.38
Relay (IsFaxUsed = 1).
2. In the Fax/Modem/CID Settings page, configure the following optional parameters:
•
'Fax Relay Redundancy Depth' (FaxRelayRedundancyDepth)
•
'Fax Relay Enhanced Redundancy Depth'
(FaxRelayEnhancedRedundancyDepth)
•
'Fax Relay ECM Enable' (FaxRelayECMEnable)
•
'Fax Relay Max Rate' (FaxRelayMaxRate)
Note: The terminating gateway sends T.38 packets immediately after the T.38
capabilities are negotiated in SIP. However, the originating device by default,
sends T.38 (assuming the T.38 capabilities are negotiated in SIP) only after it
receives T.38 packets from the remote device. This default behavior cannot
be used when the originating device is located behind a firewall that blocks
incoming T.38 packets on ports that have not yet received T.38 packets from
the internal network. To resolve this problem, the device should be configured
to send CNG packets in T.38 upon CNG signal detection (CNGDetectorMode
= 1).
13.2.1.1.2 Automatically Switching to T.38 Mode without SIP Re-INVITE
In the Automatically Switching to T.38 Mode without SIP Re-INVITE mode, when a fax
signal is detected, the channel automatically switches from the current voice coder to
answer tone mode and then to T.38-compliant fax relay mode.

To configure automatic T.38 mode:
1. In the SIP General Parameters page ( Configuration tab > VoIP menu > SIP
Definitions > General Parameters ), set the 'Fax Signaling Method' parameter to No
Fax (IsFaxUsed = 0).
2. In the Fax/Modem/CID Settings page, set the 'Fax Transport Mode' parameter to
RelayEnable (FaxTransportMode = 1).
3. Configure the following optional parameters:
•
'Fax Relay Redundancy Depth' (FaxRelayRedundancyDepth)
•
'Fax Relay Enhanced Redundancy Depth'
(FaxRelayEnhancedRedundancyDepth)
•
'Fax Relay ECM Enable' (FaxRelayECMEnable)
•
'Fax Relay Max Rate' (FaxRelayMaxRate)
13.2.1.2 G.711 Fax / Modem Transport Mode
In this mode, when the terminating device detects fax or modem signals (CED or AnsAM),
it sends a Re-INVITE message to the originating device, requesting it to re-open the
channel in G.711 VBD with the following adaptations:

Echo Canceller = off

Silence Compression = off

Echo Canceller Non-Linear Processor Mode = off

Dynamic Jitter Buffer Minimum Delay = 40

Dynamic Jitter Buffer Optimization Factor = 13