AudioCodes Media Pack MP-124, User Manual

Page: 204 / 584

User's Manual 204 Document #: LTRT-65422
MP-11x & MP-124
Table 20-1: Endpoint Phone Number Table Parameters
Parameter Description
Channel(s)
[TrunkGroup_FirstBChannel]
[TrunkGroup_LastBChannel]
Defines the device's channels (or ports) that you want to
activate. Enter the channel numbers as labeled on the device's
rear panel. You can enter a range of channels, by using the
syntax
n-m , where n represents the lower channel number and
m the higher channel number. For example, "1-4" specifies
channels 1 through 4.
Phone Number
[TrunkGroup_FirstPhoneNumber]
Defines the telephone number for the channel. For a range of
channels, enter only the first telephone number. Subsequent
channels are assigned the next consecutive telephone number.
For example, if you enter 400 for channels 1 to 4, then channel
1 is assigned phone number 400, channel 2 is assigned phone
number 401, and so on.
These phone numbers are also used for channel allocation for
IP-to-Tel calls if the Hunt Group’s 'Channel Select Mode'
parameter is set to
By Dest Phone Number .
This value can include up to 50 characters.
Notes:

If this field includes alphabetical characters and the phone
number is defined for a range of channels (e.g., 1-4), then
the phone number must end with a number (e.g., 'user1').

Phone number must be entered only as digits, without any
other characters. For example, if you wish to enter the
phone number 555-1212, it must be entered as 5551212
without the hyphen (-). If the hyphen is entered, the entry is
invalid.
Hunt Group ID
[TrunkGroup_TrunkGroupNum]
Defines a Hunt Group ID (1-99) to the channels. The same
Hunt Group ID can be assigned to more than one group of
channels. The Hunt Group ID is used to define a group of
common channel behaviors that are used for routing IP-to-Tel
calls. If an IP-to-Tel call is assigned to a Hunt Group, the call is
routed to the channel(s) pertaining to that Hunt Group ID.
Notes:

Once you have defined a Hunt Group, you must configure
the parameter PSTNPrefix (IP to Hunt Group Routing Table)
to assign incoming IP calls to the appropriate Hunt Group. If
you do not configure this table, calls cannot be established.

You can define the method for which calls are assigned to
channels within the Hunt Groups, using the parameter
TrunkGroupSettings.
Tel Profile ID
[TrunkGroup_ProfileId]
Defines a Tel Profile ID to the channels.
Note: For configuring Tel Profiles, see 'Configuring Tel Profiles'
on page 192 .
20.2 Configuring Hunt Group Settings
The Hunt Group Settings allows you to configure the following per Hunt Group:

Channel select method by which IP-to-Tel calls are assigned to the Hunt Group's
channels.

Registration method for registering Hunt Groups to selected Serving IP Group IDs.