AudioCodes Media Pack MP-124, User Manual

Page: 447 / 584

Version 6.6 447 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
[EnableSecureStartup] Enables the Secure Startup mode. In this mode, downloading the ini file to
the device is restricted to a URL provided in initial configuration (see the
parameter IniFileURL) or using DHCP.

[0] Disable (default).

[1] Enable = disables TFTP and allows secure protocols such as
HTTPS to fetch the device configuration.
Note: For this parameter to take effect, a device reset is required.
Firewall Table
Web/EMS: Internal
Firewall Parameters
[AccessList]
This table parameter defines the device's access list (firewall), which
defines network traffic filtering rules.
The format of this parameter is as follows:
[AccessList]
FORMAT AccessList_Index = AccessList_Source_IP,
AccessList_Source_Port, AccessList_PrefixLen, AccessList_Source_Port,
AccessList_Start_Port, AccessList_End_Port, AccessList_Protocol,
AccessList_Use_Specific_Interface, AccessList_Interface_ID,
AccessList_Packet_Size, AccessList_Byte_Rate, AccessList_Byte_Burst,
AccessList_Allow_Type;
[\AccessList]
For example:
AccessList 10 = mgmt.customer.com, , , 32, 0, 80, tcp, 1, OAMP, 0, 0, 0,
allow;
AccessList 22 = 10.4.0.0, , , 16, 4000, 9000, any, 0, , 0, 0, 0, block;
In the example above, Rule #10 allows traffic from the host
‘mgmt.customer.com’ destined to TCP ports 0 to 80 on interface OAMP
(OAMP). Rule #22 blocks traffic from the subnet 10.4.xxx.yyy destined to
ports 4000 to 9000.
Note: For a description of this table, see 'Configuring Firewall Settings' on
page 131 .
43.4.2 HTTPS Parameters
The Secure Hypertext Transport Protocol (HTTPS) parameters are described in the table
below.
Table 43-21: HTTPS Parameters
Parameter Description
Web: Secured Web Connection
(HTTPS)
EMS: HTTPS Only
[HTTPSOnly]
Determines the protocol used to access the Web interface.

[0] HTTP and HTTPS (default).

[1] HTTPs Only = Unencrypted HTTP packets are blocked.
Note: For this parameter to take effect, a device reset is
required.
EMS: HTTPS Port
[HTTPSPort]
Defines the local Secured HTTPS port of the device. This
parameter allows secure remote device Web management from
the LAN. To enable secure Web management from the LAN,
configure the desired port.
The valid range is 1 to 65535 (other restrictions may apply within
this range). The default port is 443.