ATTO Technology FibreBridge 2200D, Software Manual

Page: 8 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
3
ATTO Technology, Inc.
Chapter 2: Operation
There are two methods of operation: Menu Interface and Command Line Interface (CLI). The Menu
Interface is designed for human interface and follows a standard menu / choice model. The Command
Line Interface provides access to ATTO FibreBridge services through ASCII command lines. CLI is
designed primarily for use by applications such as ATTO BridgeTools as well
as “power-users”. The
services accessible through CLI are a superset of those available through the Menu Interface .
Initial Display (RS-232)
The initial display, after powering up the unit or restarting the firmware will contain the following
information:
ATTO FibreBridge XX00
© 2000 ATTO Technology, Incorporated.
Firmware version mm.mm release date dd mmm yyyy, hh:mm:ss Build zzzz
Power-On Self-Test Completion Status: GOOD.
xx Megabytes of RAM Installed.
1 1.0624 Gb/s Fibre Channel Interface.
2 Differential SCSI Interface Ports.
Power Supply A: OK
Power Supply B: OK
∗
not applicable to the ATTO FibreBridge 2200 R/D.
World Wide Name = xx xx xx xx xx xx xx xx
FibreBridge Name = xxxxxxxx
Internal Temperature = xx
Error Log Contents: NO ERRORS
For help, type HELP. To enable the menu interface, type MENU.
Ready.
This completes the ATTO FibreBridge initial display. Now the ATTO FibreBridge is in the Command Line
Interface mode of operation. Typing the MENU command enters the menu system.