ATTO Technology FibreBridge 2200D, Software Manual

Page: 24 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
19
ATTO Technology, Inc.
Menu (Immediate)
Syntax: Menu <[enabled | disabled]>
Returns: n/a
The Menu command turns the menu interface on or off. Turning on the menu interface will cause
the main menu to be displayed. In addition, other parameters will be enabled such as ECHO.
'Menu Disabled' will turn off the menu interface. Menu without any parameters will toggle the
current menu state.
RestoreConfiguration (Immediate)
Syntax: RestoreConfiguration [Default | Saved]
Returns: n/a
The ATTO FibreBridge configuration being edited will be restored to either the factory default
configuration or the configuration last saved into non-volatile memory. Note that this will not
impact the current operating ATTO FibreBridge configuration. This configuration must be saved
for the configuration changes to take effect.There is no get version of this command.
SaveConfiguration (Immediate)
Syntax: SaveConfiguration <Restart | NoRestart>
Returns: [Configuration Saved. |
Restart is necessary….
Do you wish to restart (y/n) ?|
Restarting…]
The configuration image being accessed by these services will be permanently saved in the
ATTO FibreBridge. This new configuration will become the active configuration immediately. If a
firmware restart is required to make the requested changed, the user will be prompted for a
confirmation of the restart. The user can override this confirmation request by indicating the
override value on the command line.
Note that the Restart or NoRestart parameter is optional .
Reserve (Immediate)
Syntax: Reserve
Returns :
(terse)
[enabled | disabled]
(verbose) Reserve = [enabled | disabled]
Reservation of the ATTO FibreBridge is implicit: once the configuration image is changed by any
user of services (Serial/Ethernet/Etc.,) the ATTO FibreBridge becomes
RESERVED . Executing a
SaveConfiguration, RestoreConfiguration or FcRestart will RELEASE the ATTO FibreBridge so
that other devices may access it.
When the ATTO FibreBridge services interface is reserved, Set commands are unavailable, but
Get commands are available. Note that at least one service interface must be available to the
ATTO FibreBridge at all times. This interface will always report
RELEASED status, since it may
issue set commands.