ATTO Technology FibreBridge 2200D, Software Manual

Page: 16 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
11
ATTO Technology, Inc.
ScsiPortSelTimeout
Syntax: set ScsiPortSelTimeout [PortNumber [256|128|64|32|16|8|4|2|1]]
get ScsiPortSelTimeout [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortResetOnStartup = [enabled | disabled]
Indicates the time, in milliseconds, the ATTO FibreBridge will wait for a response from a SCSI
device on the selected port after a selection request.
ScsiPortSyncTransfer
Syntax: set ScsiPortSyncTransfer [PortNumber [enabled | disabled]]
get ScsiPortSyncTransfer [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortSyncTransfer = [enabled | disabled]
Specifies whether synchronous SCSI transfers should be negotiated with devices on the specified
SCSI port. The default setting is 'enabled', enabling the ATTO FibreBridge to attempt negotiating
synchronous SCSI transfers with devices supporting synchronous SCSI for maximum
performance.
Should this be extended to enable/disable synchronous transfers based upon the physical
interface (SE, LVD, HVD, Ultra3, etc.).
ScsiPortTaggedQueuing
Syntax: set ScsiPortTaggedQueing [PortNumber [enabled | disabled]]
get ScsiPortTaggedQueing [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortTaggedQueing = [enabled | disabled]
Specifies whether tagged command queuing is allowed on the SCSI port. The default setting is
on, allowing tagged commands to be sent to devices that support tagged command queuing for
maximum performance.
SCSIPortBusSpeed
Syntax: set ScsiPortBusSpeed [PortNumber [fast | ultra | ultra2]]
get ScsiPortBusSpeed [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortUltra2 = [enabled | disabled]
This option controls the transfer rate at which the FibreBridge will attempt to negotiate with its
SCSI devices. Choices are Fast SCSI, Ultra SCSI, and Ultra2 SCSI. The Ultra2 option is only
valid if the current FibreBridge has LVD capable SCSI ports. An error will be if this parameter is
selected on a FibreBridge that does not support LVD.