ATTO Technology FibreBridge 2200D, Software Manual

Page: 27 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
22
ATTO Technology, Inc.
ATTO FibreBridge Maintenance Menu
FibreBridge Maintenance Menu Notes
A LIP Fibre Channel Port Force LIP on Fibre Channel port
B Display FibreBridge Version Information Display the initial status screen
C Restart FibreBridge Firmware Cause the unit to reload the firmware and restart
the ATTO FibreBridge
D Reset SCSI Port 1 Force reset on SCSI port 1
E Reset SCSI Port 2 Force reset on SCSI port 2
X Return to previous menu… Return to the ATTO FibreBridge main menu
ATTO FibreBridge Diagnostic Menu
FibreBridge Diagnostic Menu Notes
A Display Error Log Display the current error log entries. Entries in the
log do not necessarily mean that the unit is
damaged or inoperable
B Clear Error Log Clears the current error log
C Identify FibreBridge Identifies the ATTO FibreBridge in use
X Return to previous menu… Return to the ATTO FibreBridge main menu
Save / Restore Configuration Menu
Save / Restore Configuration Menu Notes
A Save Configuration Changes Restart/No Restart Prompt
B Restore Configuration to Default Confirmation Prompt
C Restore Configuration to Last Saved Confirmation Prompt
X Return to previous menu… Return to the FibreBridge Main Menu
Fibre Channel Configuration Menu
Fibre Channel Configuration Menu Notes
A FC-AL Hard Addressing Mode Display, Enable or Disable FC-AL hard Addressing
B FC-AL Hard Address Display or set the FC-AL hard address is Hard
Address mode is enabled
C FC-AL Arbitration Fairness Display, Enable or Disable Arbitration Fairness
D Unprocessed SCSI Command Returns Provides options for configuring SCSI port
1BUSY/QUEUE FULL response
E Fibre Channel Frame Length Display or set the Fibre Channel frame length
F Physical Device Address Descriptor Display or set the PDAM descriptor
G Logical Unit Address Descriptor Display or set the LUAM descriptor
H Virtual Device Address Descriptor Display or set the VDAM descriptor
I FC-AL Address Translation Display, Enable or Disable FC to SCSI Address
Translation
J FibreBridge Soft SCSI ID Status Display, Enable or Disable weather the hardware
or software SCSI ID is used for the ATTO
FibreBridge unit
K FibreBridge SCSI ID Display or set the soft SCSI ID of the ATTO
FibreBridge unit. This is the target ID to which the
ATTO FibreBridge itself will respond to SCSI
commands sent to the ATTO FibreBridge itself
rather than to SCSI devices attached to it
L
Full Duplex Mode (FibreBridge 2200R/D and
3200R) Display, Enabled or Disable Full Duplex
M Port Connection Mode (FibreBridge 2200R/D and
3200R) Display Prompt for connection mode