ATTO Technology FibreBridge 2200D, Software Manual

Page: 14 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
9
ATTO Technology, Inc.
FibreBridgeName
Syntax: set FibreBridgeName [name]
get FibreBridgeName
Returns:
(terse)
"name"
(verbose) FibreBridgeName = "name"
Specifies the name assigned to the ATTO FibreBridge. This is not the World Wide Name (WWN).
The ATTO FibreBridge name is an eight character name used by applications to identify
individual ATTO FibreBridge units. The specified name will be padded with spaces to a maximum
of eight characters.
FibreBridgeSoftLUN
Syntax: set FibreBridgeSoftLUN [0 – 15]
get FibreBridgeSoftLUN
Returns:
(terse)
n [(PORT1) | (NVRAM) | (FORCED)]
(verbose) FibreBridgeSoftLUN = n [(PORT1) | (NVRAM) | (FORCED)]
Specifies the soft Target ID to be used by the ATTO FibreBridge when addressed by the host.
This ID is only taken from NVRAM when the soft ID enable is set to “enabled” AND when LUN
Translation has been enabled. PORT1 indicates that the displayed value is taken from the value
of the port 1 SCSI initiator ID. NVRAM indicates that the displayed value is taken from NVRAM.
FORCED indicates that FC address translation is enabled while soft IDs are disabled so the
ATTO FiberBridge ID is forced to 0.
FibreBridgeSoftLUNEnable
Syntax: set FibreBridgeSoftLUNEnable [enabled | disabled]
get FibreBridgeSoftLUNEnable
Returns:
(terse)
[enabled | disabled]
(verbose) FibreBridgeSoftLUNEnable = [enabled | disabled]
Specifies whether the SCSI ID used by the ATTO FibreBridge when addressed by the host is
determined by the FibreBridgeSoftLUN setting, or the port 0 SCSI IIDsetting. If this is ‘enabled’
and LUN translation is enabled, the FibreBridge will report its Target ID as the value of the
FibreBridgeSoftLUN setting.
FcWWName
Syntax: get FcWWName
Returns:
(terse)
"NN NN NN NN NN NN NN NN"
(verbose) FcWWName = "NN NN NN NN NN NN NN NN
"
Reports the World Wide Name (WWN) of the FibreChannel interface. Set is not available for this
command. The least Significant 6 bits of the WWN are used as the ethernet MAC address.
RequestQueueLength
Syntax: set RequestQueueLength [16 | 32 | 64 | 128 | 255 | 256 | 512]
get RequestQueueLength