ATTO Technology FibreBridge 2200D, Software Manual

Page: 58 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
53
ATTO Technology, Inc.
Buffer ID nvram offset Buffer Description (default values*)
8: 0x44 Firmware Options (default 0x0000)
Bits 15-10 Reserved
Bit 9 ACK0 Enable 1= Use ACK0 w/ Class2
0 = Use ACK1 w/ Class2
Bit 8 Class 2 Support1 = Class 2 Enabled 0 = Class 2 Disabled
Bit 7 Reserved
Bits 6-4 Connection Mode
Buffer Value Meaning
3 Point-toPoint Preferred, Otherwise Loop Only
(unsupported)
2 Loop Preferred. Otherwise Point-toPoint
(unsupported)
1 Point-to Point only
0
Loop only
Bits 3-0 Reserved
9: Reserved
a:
0x28 Hard Address (default 0x03)
b: 0x29 Cache Options (default 0x00)
Bits 7 -2 – Reserved
Bit 1 – Write Cache Enable 1 = Write Cache Enabled 0 = Write Cache Disabled
Bit 0 - Disk Caching
1 = Disk Caching Only 0 = No Caching
c: 0x2A SCSI Adapter 1 Options (default 0x2F)
d: 0x2B SCSI Adapter 2 Options (default 0x2F)
Bits 7-6 - Reserved
Bit 5 - LVD/Ultra2 Transfers
1 = Yes 0 = No
Bit 4 - Power On Bus Reset 1 = Suppressed 0 = Not Suppressed
Bit 3 - Tagged Command Queuing 1 = On 0 = Off
Bit 2 - Wide Narrow Transfers 1 = Wide 0 = Narrow
Bit 1 - Sync/Async Transfers 1 = Sync 0 = Async
Bit 0 - Ultra/Fast Wide Transfers 1 = Ultra 0 = Fast Wide
e: Reserved
f: Reserved
10: 0x2C - 0x2E Physical Device Addressing Method (default 0x82 0x04 0x44)
Consists of 3 hex bytes bb ll tt (bb=busid, ll=lun, tt=target id).
The left hex digit is the bit number of the rightmost field bit in the LUN
.
The right hex digit is the number of bits in the field.
11: 0x32 - 0x34 Logical Unit Addressing Method (default 0x53 0x05 0x84)
See Physical Device Addressing Method.
12: 0x2F - 0x31 Virtual Device Addressing Method (default 0x02 0x63 0x24)
See Physical Device Addressing Method.
13-15: Reserved
16:
0x24 ATTO FibreBridge Options (default 0x00)
Bit 5-7: Reserved.
Bit 4: Translate QUEUE FULL to BUSY,
1 = Enable, 0 = Disable
Bit 2-3: Reserved.
Bit 1: Enable/Disable Bridge Soft SCSI LUN, 1 = Enable,
0 = Disable
(uses FibreBridge Soft Fibre LUN byte to determine actual ID)
Bit 0: Perform/Suppress LUN Translations, 1 = Perform, 0 = Suppress.