ATTO Technology FibreBridge 2200D, Software Manual

Page: 17 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
12
ATTO Technology, Inc.
ScsiPortWideTransfer
Syntax: set ScsiPortWideTransfer [PortNumber [enabled | disabled]]
get ScsiPortWideTransfer [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortWideTransfer = [enabled | disabled]
Specifies whether WIDE SCSI transfers should be negotiated. The default setting is on, allowing
wide transfer negotiation with devices supporting wide SCSI transfers.
ScsiTargets (Immediate)
Syntax: ScsiTargets [ sb ]
Returns:
(terse) [line count]
[sb ] [ st ][ sl ][Device Type][Vendor Id][Product Id][Revision][Serial Number]
(verbose) [line count]
[sb][st][sl][Device][Type][Vendor Id][Product Id]
[ sb ] [ st ] [ sl ] [ Dev Type ] [ Vendor Id ] [ Product Id ]
[Rev.][Serial Number]
[Revision][Serial Number]
Command returns a list of the SCSI devices, which are operational, on the referenced SCSI port.
The line count indicates the number of data lines following. This command is only available on the
ATTO FibreBridge 3200R when they use the latest version of firmware.
SerialPortBaudRate
Syntax: set SerialPortBaudRate [2400 | 9600 | 19200 | 38400 | 57600]
get SerialPortBaudRate
Returns:
(terse)
[2400 | 9600 | 19200 | 38400 | 57600]
(verbose) SerialPortBaudrate = [2400 | 9600 | 19200 | 38400 | 57600| 15200]
Configures the baud rate for the ATTO FibreBridge RS-232 serial port. The number of data bits
per character is fixed at 8 with no parity. The serial port supports the following baud rates: 2400,
9600, 19200, 38400, 57600 and 115200. The factory default baud rate is 9600.
SerialPortStopBits
Syntax: set SerialPortStopBits [1 | 2]
get SerialPortStopBits
Returns:
(terse)
[1 | 2]
(verbose) SerialPortStopBits = [1 | 2]
Configures the number of stop bits per character for the ATTO FibreBridge RS-232 serial port.
The number of data bits per character is fixed at 8 with no parity. The number of stop bits may be
set to 1 or 2. The factory default is 1 stop bit.
SerialPortHandshake
Syntax: set SerialPortHandshake [hard | xon | none]
get SerialPortHandshake
Returns:
(terse)
[hard | xon | none]
(verbose) SerialPortHandshake = [hard | xon | none]