ATTO Technology FibreBridge 2200D, Software Manual

Page: 28 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
23
ATTO Technology, Inc.
Fibre Channel Configuration Menu cont.’d
N Class 2 Service Parameters (FibreBridge 2200R/D
and 3200R) Display, Enable or Disabled Class 2 Service
Parameters
O Use ACK0 for Class 2 Service (FibreBridge
2200R/D and 3200R) Display, Enabled or Disabled ACKO for Class 2
Service
P Fibre Channel Initiator Mode Enable / Disable Initiator Mode
X Return to previous menu… ->FibreBridge Configuration Menu
SCSI Port Configuration Menu
SCSI Port x Configuration Menu Notes
A Initiator ID from Hardware Switch Display, Enable or Disable use of the hardware
SCSI initiator ID for the SCSI bus. Note, this
differs from the ATTO FibreBridge SCSI ID option
which sets the use of a soft or hardware ID of the
ATTO FibreBridge itself
B SCSI Initiator ID Display or set the SCSI initiator ID of the SCSI bus
C Reset SCSI Bus on Startup Display, Enable or Disable weather the SCSI bus
resets on startup of the unit
D Tagged Command Queuing Display, Enable or Disable use of Tagged
Command Queuing
E Wide SCSI Transfers Display, Enable or Disable forced (as opposed to
negotiated) Wide SCSI transfers
F Synchronous SCSI Transfers Display, Enable or Disable Synchronous SCSI
transfers
G SCSI Bus Speed Displays the transfer rate at which the FibreBridge
will attempt to negotiate with its SCSI devices.
H Selection Timeout Display or set the selection timeout for the SCSI
bus
X Return to previous menu… Return to the ATTO FibreBridge configuration
menu
Serial Port Configuration Menu
Serial Port Configuration Menu Notes
A Baud Rate Display or set the baud rate for the RS-232 port.
The baud rate may be set to 2400, 9600, 19200,
38400, 57600 or 115200 baud
B Flow Control (Handshaking) Display or set the current handshaking mode. The
handshaking mode may be set to hard (hardware),
xon (Xon/ Xoff) or none
C Stop Bits Display or set the number of bits. The ATTO
FibreBridge supports 1 or 2 stop bits
X Return to previous menu… Return to the ATTO FibreBridge configuration
menu