ATTO Technology FibreBridge 2200D, Software Manual

Page: 15 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
10
ATTO Technology, Inc.
Returns:
(terse)
nn
(verbose) RequestQueue Length = nn
Specifies the number of entries in the internal Fibre Channel request queue data structure. When
no entry count is specified, the current number of request queue entries will be displayed. When
the specified number of queue entries is zero, the request queue size will be changed to the
factory default value.
ResponseQueueLength
Syntax: set ResponseQueueLength [16 | 32 | 64 | 128 | 255 | 256 | 512]
get ResponseQueueLength
Returns:
(terse)
nn
(verbose) ResponseQueueLength = nn
Specifies the number of entries in the internal Fibre Channel response queue data structure. If
the number of entries is not specified, the current number of response queue entries will be
displayed. When the specified number of queue
entries is zero, the response queue size will be
changed to the factory default value.
ScsiIdSwitch
Syntax: set ScsiIdSwitch [PortNumber [enabled | disabled]]
get ScsiIdSwitch [PortNumber]
Returns:
(terse)
[enabled (HW) | disabled (NVRAM)]
(verbose) Port n ScsiIdSwitch = [enabled (HW) | disabled (NVRAM)]
Specifies whether the SCSI initiator ID for the specified port should be obtained by reading the
external SCSI ID switch or through the value stored in non-volatile RAM.
ScsiInitID
Syntax: set ScsiInitID [PortNumber [0-15]]
get ScsiInitID [PortNumber]
Returns:
(terse)
[0-15] [(HW) | (NVRAM)]
(verbose) Port n ScsiInitId = [0-15] [(HW) | (NVRAM)]
Specifies the SCSI initiator ID to be used on the specified SCSI port. This field contains either
the hardware switch setting (if ScsiIdSwitch is ENABLED) or the value in NVRAM (if ScsiIdSwitch
is DISABLED.)
ScsiPortResetOnStartup
Syntax: set ScsiPortResetOnStartup [PortNumber [enabled | disabled]]
get ScsiPortResetOnStartup [PortNumber]
Returns:
(terse)
[enabled | disabled]
(verbose) Port n ScsiPortResetOnStartup = [enabled | disabled]
Specifies whether the SCSI port should be reset on power-up. The default setting is to reset each
SCSI bus on startup.