ATTO Technology FibreBridge 2200D, Software Manual

Page: 13 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
8
ATTO Technology, Inc.
The FcFullDuplex command is used to enable or disable full duplex mode communications
between the ATTO FibreBridge and Fibre Channel hosts. When this option is enabled the ATTO
FibreBridge may transmit and receive Fibre Channel data simultaneously.
FcHard
Syntax: set FcHard [enabled | disabled]
get FcHard
Returns:
(terse)
[enabled | disabled]
(verbose) FcHard = [enabled | disabled]
The Fchard command is used to turn on or off Fibre Channel hard address assignment. The
current state of hard addressing is displayed when the optional parameter is missing. The default
is off or soft addressing. Under soft addressing, the ATTO FibreBridge loop address is assigned
during loop initialization.
FcHardAddress
Syntax: set FcHardAddress [address]
get FcHardAddress
Returns:
(terse)
0xaaaa
(verbose) FcHardAddress = 0xaaaa
The FcHardAddress command is used to set the value used as the FC-AL hard address. When
the optional address
is not present, the current value used for hard addressing will be displayed.
FcInitiator
Syntax: set FcInitiator [enabled | disabled]
get FcInitiator
Returns:
(terse)
[enabled | disabled]
(verbose) FcInitiator = [enabled | disabled]
The FcInitiator command is used to allow the FibreBridge to operate as an initiator on the Fibre
Channel network. This functionality is necessary for features such as Extended Copy /
Serverless Backuo to locate and send commands to Fibre Channel devices.
FcSCSIBusyStatus
Syntax: set FcSCSIBusyStatus [busy | qfull]
get FcSCSIBusyStatus
Returns:
(terse)
[ busy | qfull ]
(verbose) FcScsiBusyStatus = [ busy | qfull ]
Specifies the SCSI status value returned when the ATTO FibreBridge is unable to accept the
command due to a temporary lack of internal resources. The factory default setting is to return a
SCSI status of Queue Full.