ATTO Technology FibreBridge 2200D, Software Manual

Page: 50 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
45
ATTO Technology, Inc.
Chapter 6: NVRAM Configuration
ATTO FibreBridge 2100R NVRAM Configuration Parameters Summary
This section provides information on updating the ATTO FibreBridge 2100R flash or nvram
parameters using updater.exe (MSDOS-based utility), SCSI Read Buffer or Write Buffer
commands. The buffer ID identifies the respective field for either updater input or via the
Read/Write Buffer commands. The nvram offset is provided to facilitate interpretation of nvram
contents directly.
Buffer ID nvram offset Buffer Description (default values*)
0: n/a Flash EEPROM
1: 0x00 - 0xEF Entire FibreBridge 2100R NVRAM space
2: 0x15 - 0x1C World Wide Name
3: 0x00 Nvram Revision Level (current: 0x05)
4: 0x20 Request Queue Length (default 0x00)
Buffer Value Translated Value Buffer Value Translated Value
00 0xFF (255) 04 0x80 (128)
01 0x10 (16) 05 0x100 (256)
02 0x20 (32) 06 0x200 (512)
03 0x40 (64)
5: 0x21 Response Queue Length (default 0x00)
Buffer Value Translated Value Buffer Value Translated Value
00 0xFF (255) 04 0x80 (128)
01 0x10 (16) 05 0x100 (256)
02 0x20 ( 32) 06 0x200 (512)
03 0x40 ( 64)
6: 0x22 Firmware Options (default 0x02)
Bits 7 -2 - Reserved
Bit 1 - Fairness
1 = Loop Fairness On(default) 0 = Loop Fairness Off
Bit 0 - Hard/Soft Address 1 = Hard Addr Enabled 0=SoftAddr abled(default)
7: 0x24 Maximum Frame Length (default 0x00)
Buffer Value Translated Value Buffer Value Translated Value
00 0x800 (2048) 02 0x400 (1024)
01 0x200 (512) 03 0x800 (2048)
8: Reserved