ATTO Technology FibreBridge 2200D, Software Manual

Page: 19 / 66

ATTO Technology, Inc. ATTO FibreBridge Software Manual
- -
14
ATTO Technology, Inc.
ScsiPortReset (Immediate)
Syntax: ScsiPortReset [PortNumber]
Returns: Resetting Port Number n
Resets the specified SCSI bus. There is no get version of this command.
Temperature
Syntax: get Temperature
Returns:
(terse)
xx C
(verbose) Temperature = xx C
Reports the temperature of the unit, in C.
MaxEnclTempAlrm
Syntax: set MaxEnclTempAlrm [5 – 40]
get MaxEnclTempAlrm
Returns:
(terse) xx C
(verbose) MaxEnclTempAlrm = xx C
This option sets/displays the maximum enclosure temperature alarm of the unit in degrees
Celsius. Valid entries are between 5 and 40 degrees and above the current minimum enclosure
temperature alarm.
MinEnclTempAlrm
Syntax: set MinEnclTempAlrm [5 – 40]
get MinEnclTempAlrm
Returns:
(terse)
xx C
(verbose) MinEnclTempAlrm = xx C
This option sets/displays the minimum enclosure temperature alarm of the unit in degrees
Celsius. Valid entries are between 5 and 40 degrees and below the current maximum enclosure
temperature alarm.
ATTO FibreBridge Diagnostic Service Commands
The ATTO FibreBridge Diagnostic commands are intended to aid in validating ATTO FibreBridge
operation and diagnosing / isolating ATTO FibreBridge faults.
ErrorLog for ATTO FibreBridge 2100R
Syntax: set ErrorLog clear
get ErrorLog
Returns: [ Error Logs Cleared |
The last error code saved was xx
A xxx type error was detected since last error log clearing
Specific error text ]
Where xxx is : [ 960 |Static Memory | Synchronous DRAM | ISP2100 |
Symbios 876 A | Symbios 876 B | FibreChannel | Software]
and Specific error text is one line of descriptive error text.