ATEN VK1100, User Manual

Page: 98 / 176

ATEN Control System User Manual
88
Associate Set Flag , Condition , Change Button State , or Change Label
commands with device commands in the Commands list by dragging and
dropping them into a tree view list, which allows them to initiate together
(see
Advanced Options , page 90).
If you select the controller from the Device list, you can add the Special
commands listed below. Double-click to add, then double-click to
configure:
Delay – adds a delay in seconds. Enter a number between 0.1-180.
Relay – adds an Open, Close, Toggle or Pulse action on the selected
controller and Relay port.
D/O – adds an Open, Close, Toggle or Pulse action on the selected
controller and Digital Output port.
Serial Raw (ASCII) – adds a serial command string that is entered
for the port selected in ASCII mode.
Serial Raw (HEX) – adds a serial command string that is entered for
the port selected in HEX mode.
Telnet Raw (ASCII) – adds a telnet command string that is entered
for the device selected in ASCII mode.
TCP Raw (ASCII) – adds a TCP command string that is entered for
the port selected in ASCII mode.
TCP Raw (HEX) – adds a TCP command string that is entered for
the port selected in HEX mode.
Š
Commands – lists the commands that initiate when the button or slider
bar is used. They can include Device Commands (on, off, switch, change
setting or volume, etc.) and Conditions (Flag, Feedback) that must be met
before a command can initiate; or Changes (Set Flag, Change Button
State, Change Label, Change Group Button State, or Change Slider Bar
Level) that initiate with device commands.
When a device command has multiple values you can double-click it and
use the
Show Flag Menu* to select a device setting.