ATEN VK1100, User Manual

Page: 143 / 176

Chapter 6. ATEN Database Generator
133
Click Learn a second time to start learning mode. When the IR
Learn LED flashes green, point the IR remote at the Control Box’s
front panel IR Receiver and push a button on the remote. Press the
button on the remote just as you would when using it with the
hardware device. If the device responds to a
long hold or quick tap of
the remote’s button then you must press the button in the same
manor (long hold or quick tap) when it using for Learning mode. The
Control Box will beep and the Learn LED will light solid (then turn
off) when IR learning is successful. The LED also turns off if
Learning mode times out.
Test – Use to test if commands are sent successfully to the Control Box
and hardware device.
Click Test , a pop-up window appears to select a controller and the IR
port. Check a box to choose a controller and use the drop-down
menu to select the IR port and then click
Select .
Click Test a second time to test if the IR data transmits successfully
to the Control Box. Check the hardware device to confirm that it
responded appropriately.
The Status column reports the Learn and Test results.
„
Digital Output
Click to add an Action.
Click to create a duplicate of the Action
Click to delete the selected Action.
Š
Advanced – Click to use the Delay Interval drop-down menu to set a
timed delay for each command before it is sent to the device.