QL-120 User Guide
155
7
UW-5.1 Unwinder
Before Installing the Unwinder
Before installing the unwinder, observe the following precautions.
•
No unwinder feet should float. The unwinder must be held level constantly.
•
The unwinder must be installed on the same plane as the printer.
•
When placing the unwinder on a desk, table, or other similar surface, it must be sturdy
and stable enough to support the weight of the printer and the unwinder.
•
Do not turn the unwinder mandrel by hand to unwind the media. Turning the mandrel by
hand can result in unwinder damage.
Installing the Unwinder
1.
Ensure the power switch on the unwinder is in the off position.
2.
Arrange the unwinder and brackets as illustrated below. Refer to this illustration through
the installation process.
3.
Insert the tabs from bracket U into the slots on bracket R. These two brackets will later
be used to position the printer.
4.
Fasten the R-U bracket to the U bracket using the supplied thumb nuts. Ensure the
threaded pin is centered in the adjustment slot.
Note: These thumb nuts may need to be loosened at a later time when aligning labels
during unwinding.
R
R-U
U
UW-5.1
Summary of Contents for QuickLabel Kiaro! QL-120
Page 1: ...U S E R G U I D E...
