RW-5.1 Rewinder
QL-120 User Guide
154
6.
Feed the media under the rewinder dancer arm [5] and up around the empty label core.
The inside edge of the media should be aligned squarely with the inner flange [1].
If the media is not squarely aligned with the inner flange, adjust the position of the
rewinder as needed.
•
Loosen the thumb screws that fasten the RW-5.1 rewinder to the R-U bracket.
Slide the rewinder left/right as allowed by the adjustment slots until the media is
squarely aligned with the inner flange. Then tighten the thumb screws.
•
If a greater adjustment range is needed, loosen the thumb nuts that fasten the R-U
bracket to the R bracket. Slide the rewinder left/right as allowed by the adjustment
slots until the media is squarely aligned with the inner flange. Then tighten the
thumb nuts.
7.
Fasten the end of the media to the core with tape. Ensure the printed side faces out.
8.
Adjust the spring collar on the dancer arm. Slide the collar just before it contacts the
media. Label media should be able to move smoothly without being hindered by the
collar.
9.
Reinstall the outer flange [2] and then turn the mandrel adjustment knob [4] clockwise to
tighten the mandrel.
10.
Turn the power switch [3] on the rewinder to the on position.
When the dancer arm is in a lowered position, the rewinder mandrel will rewind media as
needed. Do not turn the mandrel by hand to rewind the media. The media rewind path is
illustrated below.
11.
Resume the print job on the printer. The rewinder will rewind media automatically as
needed. The rewinder will stop when the printer stops advancing media or when the
printer is out of media.
Summary of Contents for QuickLabel Kiaro! QL-120
Page 1: ...U S E R G U I D E...
