171
COMMAND
NAME
VALUE
SIA <value>
SIA?
Set IP Address
Dotted decimal form. Ex.
192.168.1.50
SGA <value>
SGA?
Set Gateway IP
Address
Dotted decimal form
SSM <value>
SSM?
Set Subnet Mask
Dotted decimal form
SDN <value>
SDN?
Set Device Name
Any word
MAC?
MAC Address Query
Example response:
00:20:4A:8B:B4:30
Mimic HU3
Command Set
SBI {4|3|2|1|0}
SBI?
Set Barcode Input
0=Off, 1=Serial# and Product#,
2=Serial# Only, 3=Product#
Only, 4=Run File
SAS {1|0}
SAS?
Set Autostart
1=On, 0=Off
Communication Considerations
All of the above commands (excluding the query commands) will respond with
the 06 hex (6 decimal) Acknowledge (ACK) ASCII control code if the transfer
was recognized by the instrument.
If there was an error with the command string, the instrument will respond with
15 hex (21 decimal), the Not Acknowledge (NAK) ASCII control code.
However, the presence of this response does not mean that the instrument (in
the case of these commands only) completed the command. These
commands require a restarting of the hardware that controls the Ethernet
Protocols. Because of this, you must wait before the Ethernet Card will
respond to another command. See the table below for the approximate wait
times necessary after one of the commands in the table is sent. In addition, the
current socket connection between you terminal and the Ethernet Card is no
longer valid, and you will need to close their current connection and establish a
new one.
Ethernet Card Settings Command Wait Times
IP MODE
COMMAND
WAIT TIME AFTER COMMAND
IS SENT*
Manual
SIA, SGA, SSM
8 seconds
SIM 0
14 seconds
Auto
SDN
14 seconds
SIM 1
8 seconds
Summary of Contents for HypotULTRA 7800
