73
WC383
2. Inspect the cam shoes on the movable driven sheave
for chipping, excessive scoring, or general condition.
WC384A
NOTE: Always replace the cam shoes as a complete
set.
3. Inspect the cam ramp faces for galling, scoring, or
excessive wear.
WC382
4. Inspect the key and keyways in the cam and fixed
driven sheave for excessive wear.
5. Inspect the wear bushings in the movable driven
sheave for wear or loose fit in the sheave. Replace as
a set.
WC383A
6. Inspect the spring for kinks by rolling on a flat sur-
face. The spring should roll freely with no irregulari-
ties.
7. Inspect spring ends and spring anchors in cam and
movable driven sheave for wear or enlarged spring
anchor holes.
NOTE: If any of the components fail the above
inspection, the driven pulley must be replaced.
Assembling
1. Clamp the Clutch Spring Compressor in a suitable
work vise; then set the fixed driven sheave on the
base.
WC387
2. Install the movable driven sheave onto the fixed
sheave shaft and align the match marks.
! WARNING
The clutch assemblies are under extreme spring pres-
sure, and only experienced technicians using the
proper tools should perform service on these compo-
nents. Failure to follow proper procedures could result
in serious injury or death. Always wear safety glasses
and observe proper shop techniques. Keep bystanders
clear of work area at all times.
Summary of Contents for HDX CREW 2017
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Page 151: ...150 NOTES...
