Arctic Cat HDX CREW 2017, Service Manual

Page: 40 / 152

39
Engine/Transmission
This section has been organized into sub-sections which
show a progression for the complete servicing of the Arc-
tic Cat ROV engine/transmission.

NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
To service the center crankcase halves, the engine/trans-
mission must be removed from the frame. To service top-
side, left-side, and right-side components, the engine/
transmission does not have to be removed from the
frame.

NOTE: Arctic Cat recommends the use of new gas-
kets, lock nuts, and seals and lubricating all internal
components when servicing the engine/ transmission.

NOTE: A new ROV and an overhauled ROV engine
require a “break-in” period. The first 10 hours (or
200 miles) are most critical to the life of this ROV.
Proper operation during this break-in period will
help assure maximum life and performance from the
ROV. Instruct the customer to follow the proper
break-in procedure as described in the Operators
Manual.
SPECIAL TOOLS
A number of special tools must be available to the techni-
cian when performing service procedures in this section.
Refer to the current Special Tools Catalog for the appro-
priate tool description.

NOTE: When indicated for use, each special tool
will be identified by its specific name, as shown in the
chart below, and capitalized.

NOTE: Special tools are available from the Arctic
Cat Service Department.

AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
Description p/n
Seal Protector Tool 0444-252
Crankcase Separator/Crankshaft Remover 0444-152
Magneto Rotor Remover Set 0444-254
Piston Pin Puller 0644-328
Secondary Drive Gear Holder 0444-253
Spanner Wrench 0444-240
Surface Plate 0644-016
V Blocks 0644-535