64
3. Inspect the one-way bearing for chipped surfaces,
missing rollers, or discoloration. If any of the above
conditions exist, replace the starter clutch assembly.
FI572
REPLACING STARTER CLUTCH
ASSEMBLY
1. Remove the cap screws securing the starter clutch
assembly to the flywheel; then remove from the fly-
wheel.
FI570
2. Thoroughly clean the rotor/flywheel; then install the
new clutch and secure with the cap screws after
applying a drop of red Loctite #271 to the threads.
Tighten to 26 ft-lb using a crisscross pattern. Make
sure the one-way bearing is installed with the
notches directed away from the rotor/flywheel.
FI576A
FI578
REPLACING STARTER GEAR BEARING
1. Support the starter clutch gear in a press making sure
to support the hub around the entire circumference;
then using a suitable bearing driver, press the bearing
from the gear.
FI583
2. Thoroughly clean the gear hub; then apply a drop of
green Loctite #620 to the bearing outer race and
press into the gear hub until even with the lower
chamfer radius.
FI580
INSPECTING STATOR COIL/MAGNETO
COVER ASSEMBLY
1. Inspect the stator coil for burned or discolored wir-
ing, broken or missing hold-down clips, or loose cap
screws.
2. Inspect the bearings in the magneto housing for dis-
coloration, roughness when rotated, and secure fit in
bearing bores.
Summary of Contents for HDX CREW 2017
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Page 151: ...150 NOTES...
