75
WC412
WC419
9. Turn the wing nut counterclockwise slowly allowing
the cam to contact the snap ring; then loosen slightly
and tap the cam with a plastic mallet to ensure the
snap ring is securely seated.
WC408
10. Remove the wing nut, compression yoke, and center-
ing bushing; then remove the driven pulley assembly
from the Clutch Spring Compressor.
Installing Right-Side
Components
1. Install the secondary shaft bearing housing making
sure the two alignment pins are properly positioned.
Tighten the new “patch-lock” cap screws to 28 ft-lb.
CD999
2. Install the oil pump; then tighten the screws (coated
with red Loctite #271) to 8 ft-lb.
CD988
3. Install the oil pump drive gear spacer onto the crank
balancer shaft. Grease the pin and insert it into the
shaft; then install the drive gear making sure the
raised side of the gear is facing toward the inside.
Secure the gear with the cap screw (threads coated
with red Loctite #271) and the washer. Tighten the
cap screw to 62 ft-lb.
CD992
Summary of Contents for HDX CREW 2017
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Page 151: ...150 NOTES...
