62
NOTE: It may be necessary to use a small two-jaw
puller to remove the trigger.
H1-030
GZ254
4. Loosen the clamps securing the coolant hose to the
water pump; then remove the crossover tube from
the cylinder head. Account for an O-ring.
5. Remove the two cap screws securing the water pump
to the engine; then remove the water pump.
6. Remove the cap screws securing the left-side cover
to the crankcase noting the location of the different-
sized cap screws for installing purposes.
7. Using an appropriate side case puller, remove the
side cover. Account for a gasket and two alignment
pins.
8. Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller
adapter.
NOTE: The puller has left-hand threads.
9. Using Magneto Rotor Remover Set and the appropri-
ate crankshaft protector, remove the rotor/flywheel
assembly from the crankshaft. Account for the key;
then remove the starter clutch gear assembly and
washer.
PR441
CD939A
CD940A
10. Remove the two starter gears from the crankcase not-
ing the direction of the beveled side of the starter
idler gear #2 for installing purposes; then remove the
two starter gear shafts.
CD136
Summary of Contents for HDX CREW 2017
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Page 151: ...150 NOTES...