25
HDX262B
2. Guide the shift cable into the shift cable bracket.
Install the cable end to the shift arm stud and secure
with a new E-clip. Secure the adjuster nut to the
bracket.
HDX251C
3. From under the dash, guide the shift cable into the
bracket and secure the cable end to the shift lever
using a new locknut. Secure the adjuster nut to the
bracket.
HDX261A
4. Fasten the shift cable to the chassis with the previ-
ously noted cable tie locations.
5. Shift the transmission through all positions making
sure the each gear position illuminates the appropri-
ate gears selected and that Park Indicator illuminates
only when fully in Park. Adjust as necessary.
6. Install the center footrest, seat base, seat back, and
seat.
LCD Gauge
REMOVING/INSTALLING
To remove the gauge, pull out on one side of it; then dis-
connect the multi-pin connector and remove the gauge.
PR900
To install the gauge, connect the multi-pin connector and
press the gauge into the dash.
NOTE: Ensure the rubber mounting ring is ori-
ented correctly on the tab and seats fully through the
dash.
WT601A
Front Wheel Alignment
NOTE: All measurements and adjustments must be
made with the vehicle unloaded.
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 6-12 mm (1/4-1/2 in.)
greater than the rear measurement (toe-out).
Summary of Contents for HDX CREW 2017
Page 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com...
Page 151: ...150 NOTES...
